|

The Aerospatiale Alouette III is an enlarged
and most successful development of the Alouette II, with
increased cabin capacity, improved equipment, more powerful
turbine engine and generally enhanced performance. The
prototype, designated SE 3160, was first flown on 28 February
1959, followed by the first production series known as SA 316A.
In June 1960 an Alouette III with seven people aboard
demonstrated its extraordinary performance by making landings
and take-offs at an altitude of 4810m on Mont Blanc in the
French Alps. Five months later the same Alouette III with two
crew and a 250kg payload made landings and take-offs at an
altitude of 6004m in the Himalayas - both hitherto unprecedented
achievements for a helicopter. The SA 316A was built for the
domestic and export market and, in June 1962, became subject to
a licence-production agreement with HAL in India. The first
Indian-assembled Alouette III was flown on 11 June 1965.
Various experimental developments followed,
including an all-weather variant which made its initial flight
on 27 April 1964. The subsequent SA 316B, first flown on 27 June
1968, featured strengthened main and tail rotor transmissions
and was generally slightly heavier, but could carry more
payload. It became the principal production version, with first
deliveries made in 1970, and was an immediate export success.
The Alouette III prototypes and the first two production series
were powered by Turbomeca Artouste IIIB turboshaft engines,
replaced by the Artouste IIID on the SA 316C, built in limited
numbers only.
The Alouette III's cabin is more enclosed
than that of the Alouette II, and can accommodate up to seven.
All passenger seats are easily removable to provide an
unobstructed cargo space. There is provision for an external
sling for hauling loads up to 750kg or, for the air/sea rescue
role, a hoist of 175kg capacity. Like most other light
general-purpose helicopters the Alouette III can also be used
for casualty evacuation, carrying two stretcher cases and two
seated persons behind the pilot.
Experiments with the thermically more
efficient and more economical Astazou turboshaft engine led to
the SA 319B Alouette III Astazou, which is a direct development
of the SA 316B. The first experimental SA 319B prototype was
completed and flown in 1967, but full production did not start
until 1973.
The Alouette III variants were even more
successful on the international market than those of its
predecessor, and by 1984 no less than 1,453 machines had been
sold to 190 civil and military operators in 92 countries. In
addition to licence-production by HAL at Bangalore in India
(200) similar agreements were signed with ICA-Brasov in Romania
(for 130) and Switzerland (for 60).
D.Donald "The Complete
Encyclopedia of World Aircraft", 1997

Based around the successful Alouette II
but with an improved fuselage design allowing for six passengers
and a more powerful 410kW Turbomeca Artouste III turboshaft. The
Alouette III first flew in February 1959 and incorporated
an increased diameter rotor and strengthened dynamics to
compensate for the additional power. This variant was as much a
success as the earlier Alouette II and was also sold
around the world. Used in both the utility and armed roles, a
more powerful version was developed in 1965 by fitting an
Astazou XII power-plant giving increased performance for less
fuel burn. The Alouette III was built under licence by
India and Romania.
P.Allen "The Helicopter", 1996
|
SE.3160 Alouette III |
Redesigned Alouette II with
all-metal monocoque fuselage, fully enclosed seven-seat
cabin and fixed tricycle u/c, powered by one 870/550shp
Turbomeca Artouste IIIB. Prot. F-ZWVQ FF 28 Feb. 1959.
|
|
SA.316A Alouette III |
New designation for SE.3160
revised in 1968. |
|
SA.316B Alouette III |
SA.316A with strengthened
transmission and 100kg TOGW increase. |
|
IAR-316B Alouette III |
SA.316B built in Romania by IAR. |
|
SA.316C Alouette III |
SA.316B fitted with a 870/660shp
Artouste HID turboshaft. |
|
IAR-317 Airfox |
Light attack helicopter prototype
built in Romania by IAR. |
|
SA.3164 |
Alouette III with stepped
windshield and nose-mounted 20mm canon and external
missile points. Prot FF 24 June 1964. |
|
SA.3180 Alouette |
Alouette II fitted with 450shp
Turbomeca Artouste II Astazou turbine for high-altitude
operation. Prot. F-WHHF FF 31 Jan. 1961. |
|
SA.318C Alouette Astazou |
New designation for SE.3180
revised in 1967. |
|
SA.319 Alouette III |
SA.316 fitted with 600shp
Turbomeca Astazou XIV turboshaft. Prot F-ZWVQ. |
|
SA.319B Alouette III |
Production version of SA.319
for military and civil users. |
|
HSA.316B Chetak |
SA.316B manufactured by Hindustan
in India. 200 built. |
|
IAR.316B |
SA.316B manufactured by
ICA-Brasov in Romania. |
|
SA.316B Alouette III |
SA.316B manufactured by FFA in
Switzerland. 60 built. |
Basically, the SE.3160 Alouette III is
an enlarged and more powerful development of the Alouette II,
with an Artouste turboshaft engine and a strengthened
transmission system. The cabin is enlarged to accommodate a
pilot and 6 passengers, and the tailboom is an enclosed, semi-monocoque
fuselage. First flown on 28 February 1959, the Alouette III
embodied several of the features seen during the preceding two
years in earlier Sud-Est designs. First of these to fly, on 10
May 1957, was the SE.3131 Gouverneur (F-WIEA), which was
basically an Alouette II with an Artouste engine, covered
fuselage and executive cabin seating 5 occupants including the
pilot. The SE.3140, flown on 16 May 1957 was
fundamentally a Turmo-engined Alouette II and the
SE.3150 an Artouste-powered development of it.
Series production of the Alouette III
began in 1961, after two prototype and two pre-series machines
had been built, and the aircraft received domestic type approval
on 12 December 1961. By mid-May 1968, four hundred and ninety
French-built Alouette Ill's had been ordered, and
Hindustan Aeronautics Ltd. have a licence to build a substantial
number for the Indian forces. Most Alouette Ill's are for
military customers: the Swiss Army (twenty-four) and Royal
Danish Navy (eight), and the air forces of Australia (fourteen),
Burma (thirteen), Burundi (one), Cambodia (two), Congolese
Republic (five), Dominican Republic (one), Eire (three),
Ethiopia (five), Hong Kong (two), India (thirty-seven), Ivory
Coast (two), Jordan (seven), Lebanon (seven), Malaysia
(twenty-three), Mexico (four), Nepal (one), the Netherlands
(seventy-seven), Pakistan (eight), Peru (four), Portugal
(fifty-four), Rhodesia (eight), Rwanda (two). South Africa
(fifty-four), Tunisia (four), Venezuela (twenty) and Vietnam
(two). In France, the ALAT is the prime user, though the
Armee de I'Air has three, the Aeronavale has sixteen
aboard the carrier Jeanne d'Arc, and others are used by the
Gendarmerie.
Duties of the Alouette III include
those of tactical or assault transport, flying crane (with 750
kg external sling load) or casualty evacuation (with 2
passengers and a stretchers carried inside the cabin). A
close-support version, the SA.3164 Alouette III Armee,
was flown on 24 June 1964. This carried a 20mm cannon in front
of the left-hand seat, and can be armed with 7.92mm
machine-guns, pods of 18 or 36 HVAR rockets or Nord AS.11 or
AS.12 anti-tank missiles on mountings on each side of the cabin.
A naval version with a mooring harpoon and all-weather
capability is being developed for anti-submarine and other
shipboard roles.
The Alouette III, developed in the mid
fifties, is a streamlined, rather elegant aircraft with an
extensively-glazed cabin to accommodate seven. The dynamic
components are derived from its predecessors and it has a 870shp
Artouste III turbine derated to 550shp. The usual skid landing
gear has been replaced by a fixed tricycle undercarriage.
The prototype made its first flight on 28
February 1959 and immediately aroused the interest of the French
forces, who needed a fast, well-armed machine for the war in
Algeria. Various weapons fits were examined and, apart from a
number of fixed or flexible weapons, provision was made for the
installation of wire-guided missiles.
Thus equipped and with a maximum speed of
approximately 210km/h, the Alouette III suited the armed
forces' requirements very well. After it had been in production
for three years, Sud-Aviation built a prototype expressly
designed for armed missions, with a 20mm cannon in the
redesigned nose. However, its performance was inadequate for a
combat helicopter and, moreover, by that time the war in Algeria
had ended.
At the end of 1970, the SA.316B
version with strengthened transmission was introduced, and in
1972 the SA.316C went into production with the new 870shp
Artouste HID turbine derated to 600shp. Another variant which
adopted an Astazou XIV turbine with the same power rating was
designated the SA.319B. This last version, which was in
production in the seventies, had much higher capabilities with a
25 per cent reduction in specific fuel consumption. Construction
of the SA.316B and SA.319B continued for many
years in France and was also extended to India, Pakistan,
Romania and Switzerland, where a number of both civil and
military models have been manufactured under license. By spring
1976, over 1350 Alouette III helicopters had been built
and sold to 120 operators in 69 countries.
The helicopter was also adapted for naval use
and was equipped with better navigational aids — Doppler radar,
a navigation computer, autopilot and two homing torpedoes for
ASW. In the antiship role, it carried two missiles.
G.Apostolo "The Illustrated
Encyclopedia of Helicopters", 1984

Technical data for Aerospatiale SA.316B "Alouette III"
Crew: 1, passengers: 7, engine:
1 x Turbomeca Artouste IIIB turboshaft, rated at 649kW,
main rotor diameter: 11.02m, length with rotors turning:
10.03m, height: 3.0m, take-off weight: 2200kg,
empty weight: 1143kg, max speed: 210km/h, cruising
speed: 185km/h, service ceiling: 3200m, range with
max fuel: 540km |